WaveWare Apollo T-2000 Technical Information download pdf (Page 64)

Certification Manual

- 64 -

description. Choose the proper escalation templates for each

shift and then click SAVE. When finished click DONE.

Programming Step 3 - Control Panel Configuration (Tools / Server / Device

Related / Control Panel Configuration)

- This screen allows the installer to configure the serial ports that are

used for any external devices the computer will be

communicating with. Click NEW and then label what the device

is and choose the proper Panel Type with its COM Port. Click

SAVE and DONE. NOTE, Concord Panels are always

programmed to panel type: “Advent”. WaveWare Paging

Encoders are always programmed to panel type: “Tapout”

Programming Step 4 – Points Configuration Screen (Tools / Server /

Device Related / Points Configuration)

- At this point, the installer is ready to setup the Points Configuration

Screen. This table is where all of the data that has been

entered in steps 1-3 is tied together and associated with the

zone numbers. The information that the software uses to page

out comes from columns 1 and 3. If there is no data in column

3, than column 1 is used. If there is data in column 3, column 1

is note used.

- Click NEW. The first column is the zone location or description.

The second column is the zone number. This data must be

unique for each zone, and each panel. For example, the when

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 113 114

No comments

WaveWare Apollo T-2000 Technical Information Page 64